Started the tedious process of fitting and trimming the canopy. Started by marking the center of the front and rear edges of the canopy and aligning them with the fuselage center line. Scooted canopy up to the front and marked a trim line with most of the canopy hanging on the back of the turtle deck. Trimmed front edge of canopy using an oscillating tool, then sanded with 80 grit and deburred edges. Continued to trim and sand until getting a uniform 1/16″ on front of canopy. Tapped canopy into place then taped a trim line onto the back part of the canopy. Trimmed large section off the back edge then checked fitment again. More marking, trimming, and sanding until canopy fit between windshield and turtledeck (albeit tightly). Taped sides down and noticed that sides bulge out quite a bit when canopy is relaxed. Will seek advice before proceeding.
Hours Worked: 4.07
Leave a Reply