SNB-C06: Trim System
-
Trim System Installation – Part 2
Finished trim system by installing last clamp on elevator pushrod and balance spring. Will wait to adjust until flight testing occurs. Also added torque seal to elevator push rod bolts. Hours Worked: 0.32
-
Trim System Installation – Part 1
Began trim system installation by removing lower instrument panel and drilling holes for throttle, mixture, and trim wheel. Measured and drilled hole for trim cable sleeve below seat pan. Mocked up cable run and trimmed around 18″ from cable and sleeve. Ran cable through trim adjuster and sleeve then secured to rear spar carry through…