0.125 Plate
Pitot Installation – Part 1
Leveled fuselage then temporarily installed pitot mount into RH wing to calculate spacer size needed to level pitot tube. Made 2 0.125″ spacers (0.25″ total) out of 0.125″ aluminum sheet to place under back side of pitot tube mount. Installed mount into RH wing, checked levelness, then installed screws. Installed pitot mast into mount and…
Brake System Assembly – Part 3
Manufactured master cylinder mount components out of aluminum sheet and angle stock. Because the B-Model plans do not have provisions for a center mounted brake lever, used “sport trainer” plan set from the legacy plans for part dimensions. Also substituted two 0.125″ spacer plates on each side of the mounts rather than one 0.25″ piece…
