3/4″ Phenolic Sheet
-
Rudder System Prep – Part 1
Cut rudder pedal pivot blocks from Phenolic sheet. Matched similar blocks together and rough sanded. Clamped blocks together then drilled mount holes with drill press. Temporarily bolted blocks together and sanded edges flat. Marked holes for rudder pedals then through drilled with Forstner bit. Deburred all holes and final sanded through holes. Hours Worked: 1.67
-
Fairlead Blocks
Cut -09 fairlead mount blocks from 6″ x 12″ phenolic sheet with band saw. Drilled holes in mount blocks, counterbored rivet holes, and up drilled center hole for cable fairleads. Test fit fairleads. Will hold off on installing fairleads until rudder cable installation per plan recommendation. Therefore, will not be using -10 fairlead block assembly…