AN3-14
-
Forward Fuselage Part Prep – Part 2
Assembled F10-16 idler assembly (skipping -21 and -17 sub assemblies. Used vice to press in Symmco bushings to pivot angles. Lubricated bushings and pivot bearings with LPS-2 prior to assembly. Hours Worked: 0.57
-
Aileron Bellcranks – Part 4
Drilling of holes in -13L/R and -14L/R vertical channels. Both -10 bell crank assemblies created. Two washers per assembly needed to get castle nut aligned properly. Completed -01L including final riveting and lubrication of pivot with white lithium grease. -08 clip heights on vertical stiffeners set by using right angle from rib face. -01R clecoed…
-
Initial Kit Inventory – Part 2
Inventory most of kit. Still need to organize tools and parts in small boxes Hours Worked: 8.50