SNX-W23-08
-
LH Wing Rib Assembly – Part 3
Attached W17-01L assembly to main spar. Bolt direction altered from plans to account for rivet interference. Starting inboard and working outboard, attached forward and aft ribs 1-5 to main spar and riveted into place. Forward ribs scotchbrited, acetoned, deburred, and dimpled. Aft ribs scotchbrited, acetoned, and deburred. Aft-most lightning holes in forward ribs upsized to…
-
RH Wing Rib Assembly – Part 4
Completed prep and installation of #1 and #2 forward/aft ribs and installation onto main spar. Tubing support plate installed on both forward ribs. Dimpling skipped on #1 forward rib per plans in preparation of doubler installation. Hours Worked: 0.90
-
RH Wing Rib Assembly – Part 3
Took apart RH wing box down to spars. Deburred and cleaned both main and rear spar. Began assembling wing ribs starting from #12 and working inboard. Deburred all holes in both forward and aft ribs, scotchbrited scratches, and cleaned with acetone. Forward ribs had holes dimpled for forward skin. Forward/Aft ribs #3-#12 complete. Lightning holes…
-
Pitot Mount Skin Doubler – Part 2
Drilled skin doubler to rib #5 and clecoed in place using mock skin section. Drilled and countersunk pitot mount in preparation for nutplates. Final drilling to occur once lower forward skin is clecoed in place. Creation of -08 Tubing Support Plates from scrap. Added extra 3/8″ hole on plates for wing wiring bundle to help…