Replaced F23-02 aft bulkhead and F23-03 forward lower mount angle with new parts and drilled 3/16″ holes for tailwheel mount. Located aft fuselage tail channel on rear of tail cone and pilot drilled and clecoed into place. Secured F23-04 aft lower mount angle against longerons and rear channel and drilled holes for AN3 hardware through tailwheel mount. Lower holes ended up a little close to horizontal part of mount so took grinder to flatten the fillet a little bit. Located, pilot drilled, and clecoed aft shear web to longerons, rear angle, and aft bulkhead. Flipped tail cone assembly over and pilot drilled holes in upper longerons for T12-05 tail mount angle. Located, pilot drilled, and clecoed #1 lower cross tie while checking and verifying tail cone spacing and squareness. Finally, located aft fuselage floor on bottom side of assembly and began to pilot drill and cleco floor to lower longerons.
Hours Worked: 2.55
Leave a Reply