Tweaked fitment of RH side panel by trimming a little more off of the rear side of the panel. Attached Velcro strips to back and bottom of side panel and upper longeron and seat pans. Installed side panel and checked fitment. Rough trimmed LH side panel from ABS sheet and went through a couple iterations of fitting side panel then removing to trim. Made notches in side panel for canopy latch nubs and safety pin hole. Finally got fitment correct and installed Velcro strips on panel and fuselage. Removed canopy latch knob and ground one side flat to clearance canopy safety pin then reinstalled canopy knob. Reinstalled side air vents into fuselage. Attached document holder to RH side panel with Velcro. Reinstalled seat pans and installed stick boots Velcro on forward seat pan. Installed Velcro strips for seats on pans as well.
Hours Worked: 4.60
Leave a Reply