05-16210
Brake System Assembly – Part 3
Manufactured master cylinder mount components out of aluminum sheet and angle stock. Because the B-Model plans do not have provisions for a center mounted brake lever, used “sport trainer” plan set from the legacy plans for part dimensions. Also substituted two 0.125″ spacer plates on each side of the mounts rather than one 0.25″ piece…
Throttle Bell Crank – Part 2
Installed throttle cable in center panel area. Located throttle and mixture cable pass-through locations on firewall and prepared holes for cable bulkheads. Installed both cable safes. Located throttle bellcrank assembly based on throttle cable pass through then transferred mounting holes onto firewall. Cleaned up bellcrank assembly then riveted pieces together and to firewall. Tested cable…
