AN526-632R8
ELT Installation
Located and drilled hole for ELT antenna on aft portion of turtle deck. Secured antenna to fuselage then routed and connected coax cable from antenna to ELT. Cut hole in RH #1 former for RCPI and drilled mounting holes. Installed vertical faceplate and A544 alkaline battery into RCPI (battery expires 06/19/2031) then mounted RCPI onto…
Fuselage Floor Avionics – Part 1
Clecoed forward fuselage floor back onto fuselage to start under seat component layout. Made riser mounts for ADSB, transponder, and com boxes so that nutplates could be used out of scrap aluminum. Riveted mounts to fuselage floor behind seat pan and bolted SV-COM-T25, SV-ADSB-472, and SV-XPNDR-261 units into place. Drilled holes for transponder and ADS-B…
LH Landing Light – Part 3
Laid out landing light template on LH wing and trimmed opening for landing light lens. Cleaned up edges with rotary tool and scotchbrite pads. Created upper retaining bracket and riveted into place. Created lower retaining bracket and temporarily secured with #6 screws. Opted to not use flush screws on lower retaining bracket. Hours Worked: 2.58
Pitot Mount Prep – Part 2
Removed pitot mount doubler plate from #5 rib and deburred/dimpled all holes. Doubler plate riveted to rib. Installed Dynon heated pitot controller to outboard side of #4 rib using K1000-06 nutplates (x4) and AN526-632R8 screws Hours Worked: 0.75
