AN526-832R8
-
Wing Root Wiring
Attached wing tip lights to tip light fairings then installed DT connectors. Installed lights and fairings onto tips of wings. Terminated wing root wires at bulkhead connectors and tested functions. Reinstalled pneumatic bulkhead fittings for RH wing. Installed CHT/EGT harness and ran wires through firewall grommet. Installed engine sensor harness as well. Hours Worked: 2.87
-
Avionics Sub-panel – Part 2
Created mount angle for EMS and ARINC module from scrap 0.032 sheet due to lack of clearance for modules with connectors on both ends. Riveted nut plates to vertical mount and then riveted mount to avionics shelf. Laid out backup battery, wig wag module, and fuel probe box onto shelf and marked mounting holes. Installed…
-
Trim System Installation – Part 1
Began trim system installation by removing lower instrument panel and drilling holes for throttle, mixture, and trim wheel. Measured and drilled hole for trim cable sleeve below seat pan. Mocked up cable run and trimmed around 18″ from cable and sleeve. Ran cable through trim adjuster and sleeve then secured to rear spar carry through…
-
Wing Root Electrical Connectors
Removed rigging hardware from main wing spars through the three center holes in the spar webs. Slid RH wing out slightly for better access to fuselage side. Located wing root electrical connector and cut out hole for pass through. Drilled mounting holes then used 8-32 screws to attach bulkhead connector to fuselage side. Measured out…
-
LH Landing Light – Part 2
Riveted together both sides of light mount plate. Installed #8 nutplates into mount and secured LH landing light and retaining ring to mount. Mounted complete light assembly onto forward ribs and checked operation of light Hours Worked: 0.55
-
RH Landing Light – Part 3
Replaced light retainer nutplates for #8 screws on RH landing light mount and reinstalled Hours Worked: 0.38
-
Wing Conversion Kit Inventory
Inventory of Sonex’s Wing Conversion Kit for legacy aircraft Hours Worked: 1.31
-
Initial Kit Inventory – Part 2
Inventory most of kit. Still need to organize tools and parts in small boxes Hours Worked: 8.50