AN960-516
Brake System Assembly – Part 3
Manufactured master cylinder mount components out of aluminum sheet and angle stock. Because the B-Model plans do not have provisions for a center mounted brake lever, used “sport trainer” plan set from the legacy plans for part dimensions. Also substituted two 0.125″ spacer plates on each side of the mounts rather than one 0.25″ piece…
Seatbelt Installation – Part 1
Began seatbelt installation by placing AN5 bolts in center seatbelt channel with grabber extension. Wrapped chrome ends of lap belts in painters tape to prevent scratching. Followed plans and placed buckle ends of seatbelt on inside. Set approximate lap belt angle and tightened AN5 hardware. Repeated process for outside belts. Marked all four seatbelt bolts…
Engine Mount Installation
Measured required bolt hole lengths which differed from plans. Used AN4-33A bolts for lower holes and AN4-32A bolts for upper holes. Inserted bolts into engine mount blocks then positioned mount on bolts. Torqued bolts to spec then applied torque seal. Hours Worked: 0.33
Initial Kit Inventory – Part 2
Inventory most of kit. Still need to organize tools and parts in small boxes Hours Worked: 8.50
