-
Root Rib Prep – Part 1
Creation of -02, -03, -04, and -05 angles from scrap and installation of RH root ribs in place Hours Worked: 3.05
-
RH Wing Assembly – Part 5
Clecoed in place RH Root Doubler and drilled skins in preparation of root Rib installation Hours Worked: 1.18
-
RH Wing Assembly – Part 4
Finished drilling upper and lower RH Aft skins to main spar and clecoed forward skin fully to wing. Cinched forward skin into place using rachet straps and blanketed 2×4. All RH skins in place and drilled to #40. Still need…
-
RH Wing Assembly – Part 3
Drilled RH upper aft wing skin to main spar and clecoed leading edge in place. First glance at fit looks good Hours Worked: 1.09
-
Pitot Mount Skin Doubler – Part 2
Drilled skin doubler to rib #5 and clecoed in place using mock skin section. Drilled and countersunk pitot mount in preparation for nutplates. Final drilling to occur once lower forward skin is clecoed in place. Creation of -08 Tubing Support…
-
Pitot Mount Skin Doubler – Part 1
Began creating skin doubler for AN5812 pitot Mount from .032 scrap skin. Pitot Mount profile cut in doubler and holes laid out for test fit. Doubler to mount to outboard (flat) side of #5 rib and get sandwiched between wing…
-
Trimming Wing Skins – Part 3
Trimming of forward Wing Skin per conversion plans Hours Worked: 0.33
-
Wing Leveling Stand
Creation of wing support stands. Rear spar pillar is 3″ high with 10 degree slope. Main spar pillar is 1.5″ high with 5 degree slope. Pads carpeted to protect skin Hours Worked: 0.83
-
RH Wing Assembly – Part 2
Pilot drilled lower aft wing skin to rear spar and ribs; will wait to mockup leading edge before pilot drilling main spar. Used same process as upper aft wing skin and leveled multiple times throughout process. Still need to drill…
-
RH Landing Light – Part 1
Installed nut plates in RH Ribs 11 and 12, trimmed mount plate per instructions, and installed in RH wing. Hours Worked: 1.90
-
Trimming Wing Skins – Part 2
Trimming of SNX-W19-02 to create SNX-WC01-05 Hours Worked: 0.38
-
RH Wing Assembly – Part 1
RH wing re-leveled on workbench and aft spar location set at W.S. 19″ per plans. Aft upper wing skin match drilled to ribs starting at rear spar and worked forward towards main spar. Checked level again after upper aft skin…