AN526-632R4
Engine Baffle Installation – Part 3
Removed AeroInjector needle carrier and replaced stock #2 needle with recommended #3 needle. Reinstalled needle carrier and set needle setting per manual by marking start of taper and aligning it with top of throttle slide. Reinstalled set screw and dust cap. Safety wired AeroInjector to engine via intake pipes. Decided to modify baffles to make…
Circuit Breaker Mounting
Bolted Ram mount base to RH panel cover using AN3 hardware. Cut copper bus bars to size and drilled circuit breaker holes at 0.8 inch spacing. Installed circuit breakers into RH panel cover then secured bus bar onto bottom terminals of circuit breakers with 6R4 screws. Used two separate bus bars for circuit breakers; one…
Pitot Mast Drilling
Marked mounting holes in pitot mount and tube; two per side. Drilled pilot holes with #36 drill bit. Upsized mount holes to #25 for #6 screws. Carefully tapped pitot head with 6-32 tap through mounting pads. Front left hole had screw break off inside so needed to (mostly) drill out and redrill slightly lower. Mount…
