Electrical
-
LH Landing Light – Part 1
Removed ribs #11 and #12 from LH wing assembly and installed #10 nutplates into rib. Also installed #6 grounding lug into #12 rib. Began trimming light mount plate and re assembled with clecoes Hours Worked: 1.57
-
RH Landing Light – Part 5
RH lens trimmed, attached to lower retaining clip and installed in opening with sealant around opening. Little bit of a gap on inboard edge; will monitor for water intrusion. Needed to heat lens a little with heat gun to get okay fit. Hours Worked: 2.07
-
RH Landing Light – Part 4
Created lower retaining bracket per instruction manual; substituted solid rivets for pull type. Masked off landing light lens and fit into place. Began trimming lens for width and began trimming upper lip. Hours Worked: 1.35
-
RH Wing Wiring
Created grounding lug in RH Rib #12 for tip light and landing light. Created RH wing wiring harness and routed through snap bushing in lightning holes and tubing support plates. Created new hole in main spar tip web to relocate connector aft of main spar. Maintenance loops created in pitot wiring harness and landing light…
-
RH Landing Light – Part 3
Replaced light retainer nutplates for #8 screws on RH landing light mount and reinstalled Hours Worked: 0.38
-
RH Landing Light – Part 2
Cut landing light hole into leading edge and deburred opening. Installed upper retaining hardware into wing including flush rivets. Will wait to do the rest of the installation until wing is in final form to ensure tight fit of landing light lens. Hours Worked: 1.59
-
RH Landing Light – Part 1
Installed nut plates in RH Ribs 11 and 12, trimmed mount plate per instructions, and installed in RH wing. Hours Worked: 1.90